Eagle has arp custom make bolts to our specifications.
Arp 2000 rod bolts 7 16 torque specs.
Acura nsx 3 0l m9.
Alfa romeo 2 0l gtv.
Arp head studs main studs rod bolts torque and stretch specs by admin on november 19 2010 in technical articles this is information that you can never find when you need it so here is a table for the arp head studs main studs and rod bolts torque specifcations and stretch specs.
Ad performance scat rod bolt torque specifications rod torque specsimportant installation instructions1 disassemble rods and thoroughly clean including bolt and beam threads to remove rust preventative.
Arp provides torque specs for our fasteners based on using arp ultra torque.
Aftermarket axle full thread thread in 12pt 1 2 20 x 1 950 uhl new kit.
Proper bolt torque is paramount to rod strength and life.
Formula vee m9 rod bolts.
The calculation of those values is solely up to the rod manufacturer.
The torque values represented here are intended to be for general information only not for specific installations.
Audi 2000 2005 2 7l 1995 2001 2 8l non turbo.
If you have an aftermarket connecting rod with an arp bolt please use the chart below to contact the rod manufacturer for the stretch torque value.
Bmc a b.
Eagle does not use off the shelf arp bolts.
First let s be clear.
Acura nsx 3 2l m8.
Amc 68 69 390 3 8 114 6004.
Here is a diagram of some.
Apply arp ultra torque to fastener threads and the underhead of the bolt or underside of the nut.
Each of which has a different torque requirement.
Bmc a series 3 8 206 6001.
For purposes of bolt design a rule of thumb is to size the bolts and select the material for this application such that each of the 2 rod bolts has a strength of approximately 20 000 lbs.
Arp supported speed demon 715 sets new land speed record new kit.
Install fastener hand tight.
If you re not using our specs and our lube you have no real idea what pre load you re getting.
Eagle rods are offered with a variety of different bolts.
Use torque wrench to install fastener to the torque value from the chart below.
Tap into place before installing bolts do not.
We ve done the testing where we can measure the torque applied and the resulting pre loads.
Corresponding to the total reciprocating weight.
A typical value for this reciprocating weight is in the vicinity of 20 000 lbs.
3 install rods by bringing cap and beam into alignment.
Do not use torque specs for off the shelf arp bolts.
