The first 2 numbers on all laser sails are red the last 4 numbers are black spread the sail out on a clean dry and flat surface with the starboard side right side facing forward facing up.
Applying laser sail numbers.
Draw the base lineand limit linefor the starboard numbers as shown on the positioning diagram.
How to apply laser sail numbers spread the sail out on a clean dry and flat surface with the starboard side right side facing forward facing up.
If you follow the guide your numbers and letters will comply with the class rules.
Measure 100 mm from the leech and 400 mm from the center of the middle batten pocket and make a small pencil mark.
National letters are only required at world and continental championships and other.
Follow the same method as for the starboard side starting with the number or letter closest to the leech the last digit of the full sail number or the last national letter and working along the base line away from the leech.
Spread the sail out flat on the working surface so that the port side of the sail is facing up.
Measure 100 mm from the leech and 400 mm from the center of the middle batten pocket and make a small pencil mark.
Instructions for applying sail numbers.
Instructions for applying sail numbers class rule 4 with 27 e for laser radial and 28 e for laser 4 7 require that your sail numbers and national letters if used are a certain size and colour and are placed on the sail in a certain position.
Take care on numbers with a hole to not stretch the dacron material as you apply it.
Make sure you are using the correct diagram for the design of sail you are applying the numbers to.
Measure 100 mm from the leech and 400 mm from the center of the middle batten pocket and make a small.
Before peeling off the backing place the bottom of the first number on the base line with the start point touching the limit line.
The leech back edge of the sail will be on the right hand side.
Ilca has an easy up to date guide for the application of numbers and letters published annually in the ilca handbook and available on the website as well.
Stick the corner in the desired location on the sail and smooth it out making sure there are no air bubbles.
Measure 400 mm from the fore most end of.
Working slowly continue to peel small portions of the paper off and smooth out the dacron.
Spread the sail out flat on the working surface so that the starboard side of the sail is facing up.
The leech back edge of the sail will be on the left hand side as shown in the positioning diagrams.
Measure 400 mm from the fore most end.
